Manufacture, Handling & Installation MANUFACTURE Our HUME network of well equipped factories is strategically located around Malaysia where BEBO precast components can be manufactured. Precast components will be delivered from the nearest Hume factory to suit installation requirements. HUME BEBO components are manufactured under factory controlled conditions with management and supervision by qualified and experienced professionals, thus ensuring the highest quality and reliability. HUME concrete factories are certified under the SIRIM's Quality Assurance System: MS: ISO 9002. HANDLING & INSTALLATION Arch elements are cast on their sides. The units can be transported either in an as cast position or as-installed position using temporary supporting frames. They are lifted from the lorry, rotated and set directly onto the prepared footings using proprietary anchors and spreader beams where necessary to ensure safety. Once the foundation is completed, the installation sequence can proceed as follows: Prepare leveling pads to required level and positions Place precast arch units, adjust, align and grout keyways Erect spandrel walls, wingwalls and other associated in-situ structures Place sealing materials over joints Backfill and compact - side and over filling with in stages till finish levels Installation (Twin Leaf)     Bebo Arch | Page 1 | Page 2 | Page 3 | Page 4 | Page 5 | Page 6 | Page 7 | Page 8 | Page 9 | Page 10 | Page 11 | Page 12 | Page 13 | Page 14 | Page 15 | Page 16 | Page 17 | Page 18 | Page 19 | Page 20 | Page 21 | Page 22 | Page 23   Top HUME CONCRETE MARKETING SDN BHD (8411-T) Level 2, Bangunan Pan Global, No. 1A, Jalan Tandang, P.O.Box 21, 46700 Petaling Jaya, Selangor. Hot-line: (603) 7785 5282 Tel: (603) 7783 3068 Fax: (603) 7785 1823 E-mail: Adam Hussein (HIMB-PJ)